Table of Contents
Advertisement
Four wheel (4W) steering allows the front wheels to turn
in the same direction and the rear wheels to turn in the
opposite direction of the steering wheel. The rear wheels
follow the front wheel path. Four wheel (4W) steering is
useful for a short turning radius and in muddy or sandy
conditions.
Warning
Allow for adequate clearance between the attachment
and other objects when turning. The attachment
extends beyond the front of the telehandler. The op-
erator must be aware of the maximum sweep of any
attachment being used, when turning, to avoid hitting
personnel and other objects in the area to prevent
death, serious injury, or property damage.
Warning and Fault Indicators
Warning
A fault condition may trigger a popup dialog box on
the display describing the nature of the fault during
operation. Corresponding red or amber warning
lights will illuminate to indicate the severity of the
fault. If an Engine Shutdown fault condition is pres-
ent, stop the Telehandler, follow proper shut down
procedures, tag the Telehandler with "Do Not Op-
erate" tags, and have a qualified mechanic service
or repair the Telehandler BEFORE placing it into
service again. Report all warning indicators and
fault codes to a qualified mechanic. Ignoring warn-
ing indicators or fault codes can cause improper
performance, which could result in death, serious
injury, or property damage.
Fault condition dialog boxes may pop up and warning
lights on the display will illuminate during critical circum-
stances. Some of these conditions demand immediate
attention and Telehandler servicing. If an Engine Shut-
down fault condition is present, the Telehandler should
be shut down as soon as practical to prevent serious
mechanical failure.
Some of the following indicators are green while the
engine is within normal operation range, turning yellow
when the normal operating range is exceeded. Some of
these indicators turn red and become warnings when a
particular parameter reaches or exceeds a critical level.
Battery Voltage Indicator. Dark gray at normal
operating range of 12.6 to14 V. Yellow at low
battery voltage between 11.5 to 12.5 V.
Critically Low Battery Voltage Warning, below
11.5 V.
XR5919-A
Coolant Temperature Indicator. Dark gray at
normal operating range of 180 to 205°F. High
coolant temperature indicator (yellow) between 205 and
215°F. It becomes a RED Critically High Coolant Tem-
perature Warning, above 216°F.
Low Fuel Level Indicator. It is dark gray at normal
operating level.
Critically Low Fuel Level Warning
High Hydraulic Temperature Indicator
Engine Load Indicator. Dark gray at normal
operating range. Yellow above 90%. Red
Warning at or above 99%.
Hydraulic Oil Pressure Indicator, above 20 psi.
Engine must be running above 500 RPM.
Low Hydraulic Oil Pressure Indicator, between
10 and 20 psi. Engine must be running
above 500 RPM.
Low Hydraulic Oil Pressure Warning, below
10 psi.
Service Reminder
Wait To Start Indicator
Water In Fuel Indicator
Starting Travel
Warning
Use proper safety procedures and avoid hazardous
situations while operating the telehandler to prevent
death, serious injury, or property damage.
• Check the work site for any hazards before operating
the telehandler.
• Check the work surface for loose soil conditions and
overhead power lines.
Chapter 6 – Operation
51
Advertisement
Table of Contents
