Attachment Removal - Xtreme Manufacturing XR5919-A Operation And Safety Manual

Attachment Hooks
Figure 6.11 – Pivot Pins
5. Tilt the attachment up slightly. The quick attach
adapter should be tight against the rear of the at-
tachment. Align the holes between the quick attach
adapter and attachment.
6. Insert pin completely through the attachment and
quick attach adapter.
Figure 6.12 – Quick Attach Pin
7. Insert quick attach pin keeper.
Quick Attach Pin Keeper
Figure 6.13 – Quick Attach Pin Keeper
XR5919-A
Pivot Pins
Pin
Warning
Hydraulic attachments have a maximum hydraulic
pressure rating. Failure to make sure the attachment is
equipped with a pressure reducing valve, or is rated to
be equal or greater than 3,200 psi (220.6 bar), which is
the maximum pressure of the forklift auxiliary hydraulic
system at the quick-disconnect couplers, could result in
death or serious injury.
8. Connect the quick attach couplers (this only applies
to attachments with a quick attach hydraulic system).
Quick Attach Couplers
Figure 6.14 – Quick Attach Couplers

Attachment Removal

To remove a standard carriage with forks, spread the
forks apart on the carriage shaft. This provides adequate
support for the carriage to stand alone.
1. Bring the forklift to a complete stop.
2. Move the travel select lever to NEUTRAL (N).
3. Set the parking brake switch to ON (engaged).
4. Extend the boom approximately 18 to 20 inches (0.46
to 0.5 meters).
5. With attachment 10" to 12" off of the ground, tilt the
attachment backward.
6. Disconnect the quick attach couplers (this only ap-
plies to attachments with a quick attach hydraulic
system).
Chapter 6 – Operation
55