Table of Contents
Advertisement
Chapter 4 – Controls
Boom Control Handle Functions
Function
Aux Button 1
Control auxiliary direction 1
Aux Button 2
Control auxiliary direction 2
Enable Trigger
Trigger must be enabled for
other functions of the control
handle to operate
Tilt Thumb-Stick
Control carriage tilt up/down
Enable LED
Lit when enable trigger is activated
Figure 4.44 – Joystick Button Functions
Boom Angle Indicator
The boom angle indicator is located on the left side of
the boom and is visible from the operator's seat. Use
the boom angle indicator to determine the boom angle
when referring to load capacity charts. Refer to the LOAD
CAPACITY CHARTS section of this manual for more
information.
The boom angle indicator is a plumb arrow with angular
graduations from -2.3° to +69°.
Figure 4.45 – Boom Angle Indicator
Boom Extend Letters
As the boom is extended, the boom extend letters on the
left side of the boom are visible to the operator. These
letters indicate boom extension as it corresponds to the
load capacity charts.
28
Purpose
Boom
Extend Letters
Figure 4.46 – Boom Extend Letters
Frame Level Indicator
The frame level indicator is mounted on the upper right
corner of the operator's cab. The frame level indicator
allows the operator to view if the forklift has been posi-
tioned in a level condition.
Figure 4.47 – Frame Level Indicator
Boom Maintenance Stand – Optional
This machine is equipped with a Boom Maintenance
Stand, which is used during any and maintenance activi-
ties where the boom is raised. It is a prop installed around
the rod of the lift cylinder when the boom is raised.
• When preparing to set boom stand, make sure ma-
chine is on a flat level ground and machine has no
load on the forks.
• Raise machine boom to 40 degrees for clearance and
then install the Boom Maintenance Stand prop around
the rod of the lift cylinder.
XR5919-A
Advertisement
Table of Contents
