Tri-Fold Tonneau Cover Installation; Tri-Fold Tonneau Cover Cleaning - RAM 1500 2019 User Manual

Tri-Fold Tonneau Cover Installation

To install the Tonneau Cover follow these
steps:
1. Position the folded Tonneau Cover on the
truck bed and push the cover forward
against the front of the truck bed. The
Tonneau Cover centers itself when
placed on the vehicle.
2. Slide the locking lever toward the center
of the truck bed and release the clamp,
and pull the handle downward into the
Released Position. Do this for both the
left and right side.
3. Holding the lower end of the clamp, push
it to the center and pull up. Push the
handle firmly and listen for a clicking
sound to confirm the clamps are set to
the Clamped Position.
NOTE:
Make sure the J Hook (1) locates itself under
the truck flange.
4. Disengage the stowage straps.
5. Unfold Tonneau Cover to the second
panel position.
NOTE:
The vehicle cannot be driven when the
Tonneau Cover is in this position.
6. Completely unfold the Tonneau Cover.
NOTE:
When unfolding the center and rear

panels, the sections MUST be held
together to avoid damage to the cover
material.
Unfold the panel gently. It is not recom-

mended to allow the panels to drop
under their own weight.
7. Repeat steps "2" through "3" for the rear
pair of clamps.
CAUTION!
It is the driver's responsibility to ensure
the Tonneau Cover is properly installed on
the vehicle. Failure to
procedure can result in detachment of the
Tonneau Cover from the vehicle and/or
damage to the vehicle/Tonneau Cover.

Tri-Fold Tonneau Cover Cleaning

For proper cleaning of the Tonneau Cover,
use Mopar Whitewall & Vinyl Top Cleaner
and Mopar Leather & Vinyl Conditioner/
Protectant.
follow this
65