RAM 1500 2019 User Manual page 22

NOTE:
Your vehicle is equipped with two key fobs,
one key fob can be linked to memory position
1 and the other key fob can be linked to
memory position 2.
The driver memory seat buttons are located
on the driver door, next to the door handle.
Driver Memory Seat Buttons
20
Programming The Memory Feature
To create a new memory profile, perform the
following:
1. Cycle the vehicle's ignition to the ON/
RUN position (do not start the engine).
2. Adjust all memory profile settings to
desired preferences (i.e., driver's seat,
outside mirrors, adjustable pedals (if
equipped), and radio station presets).
3. Push and release the set (S) button on
the memory switch.
4. Within five seconds, push and release
either of the memory buttons (1) or (2).
The instrument cluster display will show
which memory position has been set.
NOTE:
Memory profiles can be set without the

vehicle in PARK, but the vehicle must be
in PARK to recall a memory profile.
To set a memory profile to your key fob,

refer to "Linking And Unlinking The
Remote Keyless Entry Key Fob To
Memory" in this section.
Linking And Unlinking The Remote Keyless
Entry Key Fob To Memory
Your key fob can be programmed to recall
one of two pre-programmed memory profiles
by pushing the unlock button on the key fob.
NOTE:
Before programming your key fob you must
select the "Personal Settings Linked to Key
Fob" feature through the Uconnect Settings.
Refer to "Uconnect Settings" in "Multi-
media" in your Owner's Manual for further
information.
To program your key fob, perform the
following:
1. Cycle the vehicle's ignition to the OFF
position.
2. Select a desired memory profile 1 or 2.
NOTE:
If a memory profile has not already been set,
refer to "Programming The Memory Feature"
in this section for instructions on how to set
a memory profile.
3. Once the profile has been recalled, push
and release the set (S) button on the
memory switch.