Dual Pane Power Sunroof - If Equipped - RAM 1500 2019 User Manual

NOTE:
If three consecutive sunroof close attempts
result in Pinch Protect reversals, Pinch
Protect will disable and the sunroof must be
closed in Manual Mode.
Sunroof Maintenance
Use only a non-abrasive cleaner and a soft
cloth to clean the glass panel.
Ignition Off Operation
The power sunroof switch will remain active
for up to approximately 10 minutes after the
ignition switch is turned to the OFF/LOCK
position. Opening either front door will
cancel this feature.
NOTE:
Ignition Off time is programmable through
the Uconnect System. Refer to "Uconnect
Settings" in "Multimedia" in the Owner's
Manual for further information.
Calibration Procedure
If the sunroof "Express Operation" feature is
no longer functioning, or the sunroof is
auto-reversing while attempting to "Express
Close" but no obstruction is in the roof
opening, the sunroof can be re-calibrated per
the following steps:
1. Set the ignition to ACC or ON/RUN.
2. Close sunroof glass.
3. With sunroof in closed position, push and
hold the close switch.
4. After 10 seconds of holding switch, the
sunroof glass will cycle into the vent posi-
tion and stop.
5. Release the close switch, then within 5
seconds push and hold the close switch
again. The sunroof will cycle open and
back to closed as the switch is held.
6. Once the sunroof has stopped in the full
closed position, release the close switch.
The sunroof is now reset and ready to
use.
Dual Pane Power Sunroof — If Equipped
The power sunroof switches are located on
the overhead console between the courtesy/
reading lights.
Power Sunroof Switches
1 — Opening/Closing Sunroof
2 — Venting Sunroof
3 — Opening/Closing Sunshade
47