Rain Sensing Wipers - If Equipped; Climate Controls - RAM 1500 2019 User Manual

NOTE:
The mist feature does not activate the
washer pump; therefore, no washer fluid will
be sprayed on the windshield. The wash
function must be used in order to spray the
windshield with washer fluid.
Rain Sensing Wipers — If Equipped
This feature senses rain and snowfall on the
windshield and automatically activates the
wipers for the driver. The feature is espe-
cially useful for road splash or overspray from
the windshield washers of the vehicle ahead.
Rotate the end of the multifunction lever to
one of four settings to activate this feature.
NOTE:
This feature can be programmed through the
Uconnect system. Refer to "Uconnect
Settings" in "Multimedia" in your Owner's
Manual for further information.
The sensitivity of the system can be adjusted
with the multifunction lever. Wiper delay
position 1 is the least sensitive, and wiper
delay position 4 is the most sensitive.
NOTE:
Position 3 should be used for normal rain
conditions.
34
Positions 1 and 2 can be used if the driver
desires less wiper sensitivity. Position 4 can
be used if the driver desires more sensitivity.
Place the wiper switch in the O (off) position
when not using the system.
NOTE:
The Rain Sensing feature will not operate

when the wiper switch is in the low or
high-speed position.
The Rain Sensing feature may not func-

tion properly when ice, or dried salt water
is present on the windshield.
Use of Rain-X or products containing wax

or silicone may reduce Rain Sensing
performance.
The Rain Sensing system has protection
features for the wiper blades and arms, and
will not operate under the following condi-
tions:
Low Ambient Temperature — When the igni-

tion is first turned ON, the Rain Sensing
system will not operate until the wiper
switch is moved, vehicle speed is greater
than 0 mph (0 km/h), or the outside
temperature is greater than 32°F (0°C).
Transmission In NEUTRAL Position — When

the ignition is ON, and the transmission is
in the NEUTRAL position, the Rain
Sensing system will not operate until the
wiper switch is moved, vehicle speed is
greater than 3 mph (5 km/h), or the gear
selector is moved out of the NEUTRAL
position.
Remote Start Mode Inhibit — On vehicles

equipped with Remote Starting system,
Rain Sensing wipers are not operational
when the vehicle is in the remote start
mode. Once the operator is in the vehicle
and has placed the ignition switch in the
RUN position, Rain Sensing wiper opera-
tion can resume, if it has been selected,
and no other inhibit
(mentioned previously) exist.

CLIMATE CONTROLS

The Climate Control System allows you to
regulate the temperature, air flow, and direc-
tion of air circulating throughout the
vehicle. The controls are located on the
touchscreen (if equipped), on the sides of
the touchscreen, or on the instrument panel
below the radio.
conditions