Flash-To-Pass; Automatic Headlights - RAM 1500 2019 User Manual

on the inside rearview mirror or a windshield
mounted camera. These cameras detect
vehicle specific light and automatically
switch from high beams to low beams until
the approaching vehicle is out of view.
NOTE:
The Automatic High Beam Headlamp

Control can be turned on or off by
selecting "ON" under "Auto Dim High
Beams" within your Uconnect settings, as
well as turning the headlight switch to the
AUTO position. Refer
Settings" in "Multimedia" in your Owner's
Manual for further information.
Broken, muddy, or obstructed headlights

and taillights of vehicles in the field of
view will cause headlights to remain on
longer (closer to the vehicle). Also, dirt,
film, and other obstructions on the wind-
shield or camera lens will cause the
system to function improperly.
To opt out of Advanced Auto High Beam

Sensitivity Control in the rearview mirror
(default setting) and enter Reduced High
Beam Sensitivity Control (not recom-
mended), turn the ignition ON and toggle
the high beam lever six full on/off cycles
within ten seconds. The system will return
to the default setting once the ignition is
turned OFF.
30
If the windshield or Automatic High Beam
Headlamp Control mirror is replaced, the
mirror must be re-aimed to ensure proper
performance. See a local authorized dealer.
To Activate
1. The Automatic High Beams are enabled
through the Uconnect system. Refer to
"Uconnect Settings" in "Multimedia" in
the Owner's Manual for further informa-
tion.
to "Uconnect 2. Turn the headlight switch to the AUTO
headlight position.
3. Push the multifunction lever away from
you (toward front of vehicle) to engage
the high beam mode.
NOTE:
The Automatic High Beams will not activate
until the vehicle is at or above 12 mph
(20 km/h).
To Deactivate
1. Pull the multifunction lever toward you
(or rearward in vehicle) to manually deac-
tivate the system (normal operation of
low beams).
2. Push back on the multifunction lever to
reactivate the system.
The Automatic High Beams can also be
deactivated through the Uconnect system.
Refer to "Uconnect Settings" in "Multi-
media" in the Owner's Manual for further
information.

Flash-To-Pass

You can signal another vehicle with your
headlights by lightly pulling the multifunc-
tion lever toward you. This will cause the
high beam headlights to turn on, and remain
on, until the lever is released.

Automatic Headlights

This system automatically turns your head-
lights on or off based on ambient light levels.
To turn the system on, turn the headlight
switch to the extreme clockwise position
aligning the indicator with the AUTO on the
headlight switch. When the system is on, the
Headlight Time Delay feature is also on. This
means your headlights will stay on for up to
90 seconds after you turn the ignition switch
OFF. To turn the Automatic System off, turn
the headlight switch counterclockwise to the
O (off) position.
NOTE:
The engine must be running before the head-
lights will come on in the Automatic mode.