RAM 1500 2019 User Manual page 23

4. Push and release button (1) or (2)
accordingly. "Memory Profile Set" (1 or
2) will display in the instrument cluster.
5. Push and release the lock button on the
key fob within 10 seconds.
NOTE:
Your key fob can be unlinked to your memory
settings by pushing the set (S) button, and
within 10 seconds, followed by pushing the
unlock button on the key fob.
Memory Position Recall
NOTE:
The vehicle speed must be lower than 5 mph
(8 km/h) to recall memory positions. If a
recall is attempted when the vehicle speed is
greater than 5 mph (8 km/h), a message will
be displayed in the instrument cluster
display.
Driver One Memory Position Recall
To recall the memory settings for driver

one using the memory buttons on the door
panel, push memory button (1).
To recall the memory settings for driver

one using the key fob, push the unlock
button on the key fob linked to memory
position 1.
Driver Two Memory Position Recall
To recall the memory setting for driver two

using the memory buttons on the door
panel, push memory button (2).
To recall the memory settings for driver

two using the key fob, push the unlock
button on the key fob linked to memory
position 2.
A recall can be cancelled by pushing any of
the memory buttons during a recall (S, 1, or
2). When a recall is canceled, the driver's
seat and the power pedals (if equipped) stop
moving. A delay of one second will occur
before another recall can be selected.
Easy Entry/Exit Seat
This feature provides automatic driver's seat
positioning to enhance driver mobility when
entering and exiting the vehicle.
The distance the driver's seat moves depends
on where you have the driver's seat positioned
when you remove the key fob from the ignition.
When you remove the key fob from the igni-

tion, the driver's seat will move about
2.4 inches (60 mm) rearward if the driver's
seat position is greater than or equal to
2.7 inches (67.7 mm) forward of the rear
stop. The seat will return to its previously set
position when you place the ignition into the
ACC or RUN position.
When you remove the key fob from the igni-

tion, the driver's seat will move to a position
0.3 inches (7.7 mm) forward of the rear stop
if the driver's seat position is between
0.9 inches and 2.7 inches (22.7 mm and
67.7 mm) forward of the rear stop. The seat
will return to its previously set position when
you place the ignition to the ACC or RUN
position.
The Easy Entry/Easy Exit feature is disabled

when the driver's seat position is less than
0.9 inches (22.7 mm) forward of the rear
stop. At this position, there is no benefit to
the driver by moving the seat for Easy Exit or
Easy Entry.
Each stored memory setting will have an asso-
ciated Easy Entry and Easy Exit position.
NOTE:
The Easy Entry/Exit feature is not enabled when
the vehicle is delivered from the factory. The
Easy Entry/Exit feature is enabled (or later
disabled) through the programmable features
in the Uconnect system.
Refer to "Uconnect Settings" in "Multimedia"
in the Owner's Manual for further information.
21