Engine Block Heater - If Equipped - RAM 1500 2019 User Manual

If the vehicle is not in PARK and the driver exits
the vehicle with the engine running, the vehicle
may AutoPark.
AutoPark will engage when all of these
conditions are met:
Vehicle is equipped with a rotary shifter

and an 8-speed transmission
Vehicle is not in PARK

Vehicle speed is 1.2 MPH (1.9 km/h) or

less
Driver's seat belt is unbuckled

Driver's door is ajar

Brake Pedal is not depressed

The MESSAGE "AutoPark Engaged Shift to P
then Shift to Gear" will display in the instru-
ment cluster.
NOTE:
In some cases the ParkSense graphic will be
displayed in the instrument cluster, causing
the "AutoPark Engaged Shift to P then Shift to
Gear" to not be seen. In these cases, the
shifter must be returned to "P" to select
desired gear.
130
If the driver shifts into PARK while moving, the
vehicle may AutoPark.
AutoPark will engage ONLYwhen vehicle
speed is 1.2 MPH (1.9 km/h) or less.
The MESSAGE "Vehicle Speed is Too High to
Shift to P"will be displayed in the instrument
cluster if vehicle speed is above 1.2 MPH
(1.9 km/h).
WARNING!
If vehicle speed is above 1.2 MPH
(1.9 km/h), the transmission will default
to NEUTRAL until the vehicle speed drops
below 1.2 MPH (1.9 km). A vehicle left in
the NEUTRAL position can roll. As an
added precaution, always
parking brake when exiting the vehicle.
4WD LOW — If Equipped
AutoPark will be disabled when operating the
vehicle in 4WD LOW.
The MESSAGE "AutoPark Disabled" will be
displayed in the instrument cluster.
Additional customer warnings will be given
when all of these conditions are met:
Vehicle is not in PARK

Driver's Door is ajar

Vehicle is in 4WD LOW range

The MESSAGE "AutoPark Not Engaged" will
be displayed in the instrument cluster. A
warning chime will continue until you shift
the vehicle into PARK or the Driver's Door is
closed.
ALWAYS DO A VISUAL CHECK that your vehicle
is in PARK by looking for the "P" in the
Instrument Cluster Display and near the
shifter. As an added precaution, always
apply the
apply the parking brake when exiting the
vehicle.
ENGINE BLOCK HEATER —
IF EQUIPPED
The engine block heater warms the engine,
and permits quicker starts in cold weather.
Connect the cord to a standard 110-115 Volt
AC electrical outlet with a grounded,
three-wire extension cord.