RAM 1500 2019 User Manual page 146

NOTE:
The vehicle will automatically enter Aero Mode
when the vehicle speed remains between
62 mph (100 km/h) and 66 mph (106 km/h)
for greater than 20 seconds or if the vehicle
speed exceeds 66 mph (106 km/h).
Normal Ride Height (NRH) – This is the

standard position of the suspension and is
meant for normal driving.
Off-Road (OR) (Raises the vehicle approxi-

mately 1 in (26 mm)) – This position is
intended for off-roading use only where
maximum ground clearance is required.
To enter OR, push the height selector
switch up once from the NRH position
while vehicle speed is below 20 mph
(32 km/h). While in OR, if the vehicle
speed exceeds 25 mph (40 km/h) the
vehicle height will be automatically
lowered to NRH. Off-Road may not be
available due to vehicle payload, an instru-
ment cluster display message will be
shown when this occurs.
Refer to "Instrument Cluster Display" in
"Getting To Know Your Instrument Pan-
el" in your Owner's Manual for further in-
formation.
144
Aero Mode (Lowers the vehicle approximately

.6 in (15 mm)) – This position provides
improved aerodynamics by lowering the
vehicle. The vehicle will automatically
enter Aero Mode when the vehicle speed
remains between 62 mph (100 km/h) and
66 mph (106 km/h) for greater than 20
seconds or if the vehicle speed exceeds
66 mph (106 km/h). The vehicle will
return to NRH from Aero Mode if the
vehicle speed remains between 30 mph
(48 km/h) and 35 mph (56 km/h) for
greater than 20 seconds or if the vehicle
speed falls below 30 mph (48 km/h).
To enter Aero Mode manually push the
height selector switch down once from
NRH at any vehicle speed. To return to
NRH push the height selector switch up
once while vehicle speed is less than
56 mph (90 km/h).
NOTE:
Automatic Aero Mode may be disabled
through vehicle settings on your Uconnect
Radio.
Entry/Exit Mode (Lowers the vehicle approxi-

mately 3 in (73 mm)) – This position lowers
the vehicle for easier passenger entry and
exit as well as lowering the rear of the
vehicle for easier loading and unloading of
cargo. To enter Entry/Exit Mode, push the
height selector switch down twice from the
NRH while the vehicle speed is below
33 mph (53 km/h). Once the vehicle
speed goes below 15 mph (24 km/h) the
vehicle height will begin to lower. If the
vehicle speed remains between 15 mph
(24 km/h) and 25 mph (40 km/h) for
greater than 60 seconds, or the vehicle
speed exceeds 25 mph (40 km/h) the
Entry/Exit change will be cancelled. To
return to Normal Height Mode, push the
height selector switch up twice while in
Entry/Exit or drive the vehicle over 15 mph
(24 km/h). Entry/Exit mode may not be
available due to vehicle payload, an instru-
ment cluster display message will be
shown when this occurs.
Refer to "Instrument Cluster Display" in
"Getting To Know Your Instrument Pan-
el" in your Owner's Manual for further in-
formation.