Using Homelink; Security; Troubleshooting Tips - RAM 1500 2019 User Manual

It may be helpful to unplug the device during
the cycling process to prevent possible over-
heating of the garage door or gate motor.
1. Cycle the ignition to the ON/RUN posi-
tion.
2. Place the hand-held transmitter 1 to
3 inches (3 to 8 cm) away from the
HomeLink button you wish to program
while keeping the HomeLink indicator
light in view.
3. Continue to press and hold the HomeLink
button, while you press and release
("cycle") your hand-held transmitter
every two seconds until HomeLink has
successfully accepted the frequency
signal. The indicator light will flash
slowly and then rapidly when fully
trained.
4. Watch for the HomeLink indicator to
change flash rates. When it changes, it is
programmed. It may take up to 30
seconds or longer in rare cases. The
garage door may open and close while
you are programming.
5. Press and hold the programmed Home-
Link button and observe the indicator
light.
54
NOTE:
If the indicator light stays on constantly,

programming is complete and the garage
door/device should activate when the
HomeLink button is pressed.
To program the two remaining HomeLink

buttons, repeat each step for each
remaining button. DO NOT erase the
channels.
If you unplugged the garage door opener/
device for programming, plug it back in at
this time.
Reprogramming A Single HomeLink Button
(Canadian/Gate Operator)
To reprogram a channel that has been previ-
ously trained, follow these steps:
1. Cycle the ignition to the ON/RUN position.
2. Press and hold the desired HomeLink
button until the indicator light begins to
flash after 20 seconds. Do not release the
button.
3. Without releasing the button, proceed with
"Canadian/Gate Operator Programming"
step 2 and follow all remaining steps.

Using HomeLink

To operate, push and
programmed HomeLink button. Activation
will now occur for the programmed device
(i.e. garage door opener, gate operator, secu-
rity system, entry door lock, home/office
lighting, etc.) The hand-held transmitter of
the device may also be used at any time.

Security

It is advised to erase all channels before you
sell or turn in your vehicle.
To do this, push and hold the two outside
buttons for 20 seconds until the orange indi-
cator flashes. Note that all channels will be
erased. Individual channels cannot be
erased.
The HomeLink Universal Transceiver is
disabled when the Vehicle Security Alarm is
active.

Troubleshooting Tips

If you are having trouble programming
HomeLink, here are some of the most
common solutions:
Replace the battery in the Garage Door

Opener hand-held transmitter.
release the