RAM 1500 2019 User Manual page 194

CAUTION!
Do not attempt to raise the vehicle by
jacking on locations other than those
indicated in the Jacking Instructions for
this vehicle.
1. Remove the spare wheel, jack, and tools
from storage.
2. Using the lug wrench, loosen, but do not
remove, the wheel nuts by turning them
counterclockwise one turn while the
wheel is still on the ground.
3. Assemble the jack and jacking tools.
Connect the jack handle driver to the
extension, then to the lug wrench.
Assembled Jack And Tools
4. Placement of the jack is critical.
192
NOTE:
Keep the jack and tools aligned with raising the
vehicle.
Jack / Extensions Placement
Front Jacking Location
When changing a front wheel, place the
scissor jack under the rear portion of the
lower control arm as shown. Access the front
jacking location from behind the front tire.
Front Lifting Point
Front Jacking Location
Rear Jacking Location
Operate the jack using the extension with
jack hook and the lug wrench. The exten-
sion tubes may be used but is not re-
quired.
When changing a rear wheel, assemble
the extension with jack hook to the jack
and connect the extension tubes. Access
the rear jacking location from behind the
rear tire. Place the jack under the Jack
Lifting Point located on the rear axle low-
er control arm bracket. Then locate the
slot in the jack lift plate onto the rear axle
Jack Lifting Point. Attach the extension
with jack hook extending to the rear of
the vehicle.