Prepare The Flow Paths - GE AKTA GO Operating Instructions Manual

5.1

Prepare the flow paths

Introduction
The ÄKTA go instrument, as delivered, is prepared with a default flow path. The modules
in this flow path must be defined in the software, see
your system, on page
some additional valves and monitors. If the modules in the flow path on the instrument
are changed, the System properties in the software must be updated.
ÄKTA go Operating Instructions 29360951 AC
55. It is possible to remove modules from the flow path and to add
CAUTION
Fasten bottles. If bottles are being fastened to the rails at the front
or side panels, the appropriate holders must be used. Shattered
glass from falling bottles might cause injury. Spilled liquid may
cause fire hazard and personal injury.
CAUTION
Max. weight on top tray. Do not place containers with a volume
of more than 2 liters each on the top tray. The total allowed weight
on the top tray is 10 kg.
CAUTION
Avoid spillage and overflow during collection. Make sure that
outlet tubing is connected to the outlet, Out1 or Frac, that there is
a vessel to collect from Out1, and that a fraction collector is con-
nected and loaded with correct tubes.
CAUTION
Avoid spillage and overflow from waste. Make sure that the waste
tubing is inserted in an appropriate waste container and secured
in place.
5 Prepare the system for a run
5.1 Prepare the flow paths
Section 4.3.3 Adapt UNICORN to
61