GE AKTA GO Operating Instructions Manual page 44

4 Installation
4.2 Hardware installation
4.2.1 Connect the system
Connector illustration
The illustration below shows where the connectors are located on the ÄKTA go instrument.
For connectors on the computer equipment, refer to the manufacturer´s documentation.
Connect to power
Follow the steps below to connect power to the ÄKTA go instrument and the computer.
Step
1
2
3
44
Action
Select the correct power cord to be used. Each instrument is delivered with
2 alternative power cords:
Power cord with US-plug, 2 m
•
Power cord with EU-plug, 2 m
•
Recycle the power cord that is not to be used.
Connect the power cord to the Power input connector on the back of the
instrument and to a grounded power outlet 100-240 V~, 50/60 Hz.
Connect the computer to a power source using the manufacturer's instruc-
tions.
ÄKTA go Operating Instructions 29360951 AC