Kohler EKOZD Series Service page 62

SiteTecht Parameter
Engine Total Run Time Loaded
Engine Total Run Time Unloaded
Engine Total Number Of Starts
Genset Total Energy
Engine Maintenance Period Hours
Genset Date Time Of Last Maintenance
Engine Run Time At Reset Maintenance
Engine Run Time Until Maintenance
Genset Controller Hours Of Operation Since
Maintenance
Engine Run Time Since Maintenance
Engine Run Time Loaded Since Maintenance
Engine Run Time Unloaded Since Maintenance
Engine Number Of Starts Since Maintenance
Genset Energy Since Maintenance
Engine Last Start Time
Last Run Length
62 Section 2 Operation
Write Decision-Maker
Access Units
User Interface
None h Hours Loaded: #####hrs
None h Hours Unloaded: #####hrs
None Total # of Starts: ########
None kW-h kW Hours: #####kWh
Always h
None Last Maintenance: ##/##/####
None h
None h
None h Op Hrs Since Maint: ####hrs
None h Eng Hrs Since Maint: ####hrs
None h Loaded Since Maint: ####hrs
None h Unloaded Since Maint: ####hrs
None Starts Since Maint: ###
None kW-h kW Hrs Since Maint: ####kWh
None Last Start: ##/##/####
None h Last Run Length: ####hrs
3500
r
Notes
The total number of hours
that the engine has been
running while supplying
more than 1% of rated
genset load
The total number of hours
that the engine has been
running while supplying
less than 1% of rated
genset load
The total number of times
that the engine was
started via the genset
controller
The total amount of
energy that the genset
has produced
The number of hours
between engine
maintenance requirement
The time on the controller
system clock when the
last maintenance was
performed
The total number of hours
that the engine had been
running when the last
maintenance was
performed
The total number of
engine run hours that
remain before engine
maintenance is required
The number of hours that
power has been applied
to the genset controller
since maintenance was
performed
The number of hours that
the engine has been
running since
maintenance was
performed
The number of hours that
the engine has been
running while supplying
more than 1% of rated
genset load, since
maintenance was
performed
The total number of hours
that the engine has been
running while supplying
less than 1% of rated
genset load, since
maintenance was
performed
The number of times that
the engine was started
via the genset controller,
since maintenance was
performed
The amount of energy
that genset has produced
since maintenance was
performed
The date and time that
the engine was last
started via the genset
controller
The length of time that
the engine ran the last
time it was started via the
genset controller
TP-6953 7/19