Kohler EKOZD Series Service page 281

16.1 Disassembly
1. Remove the junction box panels. Disconnect all
controller-to-engine
harnesses and wiring. Remove the junction box
and controller as a unit.
2. Remove the fan guard from the alternator adapter.
3. Disconnect the two-lead P6 connector at the LED
optic board.
4. Remove the LED optic board holder from the end
bracket (four screws). See Figure 16-2.
1
2
3
4
1. End bracket
2. LED optic board holder mounting screws (qty. 4)
3. LED optic board holder
4. LED optic board
Figure 16-2 Removing LED Optic Board Holder
5. Remove the LED optic board from the LED optic
board holder (one screw).
6. Remove the FRX activator board from the exciter
armature assembly.
7. Remove the FRX activator spacer from the exciter
armature. See Figure 16-4. Disconnect the exciter
armature and rotor leads (AC1, AC2, AC3, F1, and
F2) from the spacer.
TP-6953 7/19
and engine-to-alternator
TP-6783-4
1
2
3
1. Exciter armature
2. FRX activator board
3. FRX activator mounting screws (qty. 3)
Figure 16-3 Removing FRX Activator Board
1
2
3
1. FRX activator spacer
2. Spacer mounting screws (qty. 3)
3. FRX activator mounting screw locations
Figure 16-4 Removing FRX Activator Spacer
1
2
3
1. Lead with terminal
2. Silkscreen positioning box
3. FRX activator board
Figure 16-5 FRX Activator Board Silkscreen Boxes
Section 16 Additional 4PX/4QX Alternator Information
TP-6783-4
TP-6783-4
GC70113B-
281