Controller Parameters - Kohler EKOZD Series Service

Fault Sensing
Condition Mechanism
Intake air ECM
temperature
Fuel return ECM
temperature
AC sensing loss Integral voltage
metering
Alternator CTs and integral
protection metering
ECM model CAN parameter file
mismatch
Run relay coil Internal hardware
overload and software
Sensor supply CAN (John Deere
voltage only)
Starter relay Internal hardware
coil overload and software
Figure 2-21 Fault Parameter Default Table

2.9 Controller Parameters

The controller parameters list is an overview of the
various features and functions of the controller. Certain
features function only when optional accessories are
connected.
TP-6953 7/19
Fault
Condition
Engine specific.
Consult engine
specifications.
100_C
No AC voltage at
controller
Exceeding alternator
protection curve
ECM comms don't Prior to crank
match
Relay coil exceeds
max. current
ECM
Note: Use Kohlerr SiteTecht software and a personal
When Inhibit
Active Time
Running ECM
Running ECM
Running 10 sec.
Running Crank Disconnect
Running 0
Running ECM
Cranking Cranking
computer connected to the controller's USB port
to configure the controller parameters.
TP-6701, SiteTech Software Operation Manual,
for instructions.
Time Display
Delay Cleared On
ECM ECM
ECM ECM
3 sec.
0 Fault removal
and reset
ECM
See
Section 2 Operation 59