Table of Contents
Advertisement
9
Electrical system
9.4.1
Switching on/off:
9.4.2
9.4.3
Measures:
94
Battery cut-off switch
After switching the battery cut-off switch back on again: Put the basic
light (lighting in the entrance area), entrance step, heater and spare 4
back into service (depending on the model). To do so, switch on the
12 V main switch briefly. This also applies if the living area battery was
disconnected and then reconnected.
The battery cut-off switch disconnects all the living area 12 V appliances.
This prevents the living area battery from slowly discharging if the vehicle is
not used for a longer period of time (e.g. temporary lay-up).
The batteries can still be charged by the transformer/rectifier when the bat-
tery cut-off switch is turned off.
Push the battery cut-off switch upwards: Battery On ("Batterie Ein").
Push the battery cut-off switch downwards: Battery Off ("Batterie Aus").
Battery selector switch
If the battery selector switch is set incorrectly, there is a risk of gener-
ating oxyhydrogen gas. Danger of explosion!
Incorrect setting of the battery selector switch damages the living area
battery.
The factory settings of the battery selector switch must not be changed.
Battery monitor
You must fully recharge a discharged living area battery as soon as pos-
sible.
The battery monitor in the transformer/rectifier monitors the voltage in the
living area battery.
If the voltage of the batteries falls below 10.5 V, the battery monitor in the
transformer/rectifier switches off all the 12 V appliances.
Switch off all electrical appliances that are not absolutely essential at the
corresponding switch.
If necessary, use the 12 V main switch to switch the 12 V power supply
back on for a short while. This is only possible, however, when the bat-
tery voltage is above 11 V. If the voltage is below this level, the 12 V
power supply cannot be switched on again until the living area battery
has been recharged.
Capron - 3141417 - 03/20 - EHG-0021-02EN
Advertisement
Table of Contents
