To Heat Properly; Heater And Production Of Hot Water (Truma Combi) - Capron T58 Manual

10.2.3
Hot air distribution
Adjusting the air outlet
nozzles
10.2.4
Operating modes
Capron - 3141417 - 03/20 - EHG-0021-02EN

To heat properly

Fig. 107 Air outlet nozzle (hot-air
heater)
Several air outlet nozzles (Fig. 107) are built into the vehicle. Pipes conduct
the warm air to the air outlet nozzles. Turn the air outlet nozzles in a suitable
position so the air can escape as required. To avoid draft close the air outlet
nozzles on the dashboard and set the air distribution of the base vehicle to
air circulation.

Fully open: Full hot air stream

Half or partially open: Reduced hot air stream
When five air outlet nozzles are completely opened, less warm air escapes
through each nozzle. However, if only three air outlet nozzles are opened,
more warm air flows out of each nozzle.

Heater and production of hot water (Truma Combi)


If the heater is not in operation when there is a risk of frost, empty the
domestic water container.
The power supply of the heating control system cannot be interrupted by
means of the 12 V main switch.
The heater is operated with gas.
Fig. 108 Operating unit
The heater can be operated in different operating modes:

Winter operation (with or without production of hot water)

Summer operation (only production of hot water)
Appliances
1 Summer operation water tempera-
ture 60 °C
2 Summer operation water tempera-
ture 40 °C
3 Off
4 Winter operation "Only heater"
5 Winter operation "Heater and pro-
duction of hot water"
6 Rotary switch (external ring)
7 Indicator lamp "Heater operation"
(green)
8 Temperature control knob
9 Indicator lamp "Heating up period of
production of hot water" (yellow)/
"Fault" (red)
10
105