Topping Up The Water - Capron T58 Manual

11.2.3
Capron - 3141417 - 03/20 - EHG-0021-02EN

Position the vehicle horizontally.

Switch on the 12 V power supply on the panel.
Fig. 127 Safety/drainage valve open

Close the safety/drainage valve. Turn the knob (Fig. 127,1) perpendicu-
lar to the safety/drainage valve and push the push button (Fig. 127,2) in.
The closed safety/drainage valve is shown in Fig. 128. If the tempera-
ture is below 6 °C, the safety/drainage valve cannot be closed.

Close all water taps.

Close the drainage opening of the water tank.

Open the drinking water filler neck on the outside of the vehicle.

Fill the water tank with drinking water. Use a water hose, a water canis-
ter with a funnel or similar for filling.

Set all the water taps to "Hot" and open them. The water pump is turned
on. The warm water pipes are filled with water.

Keep the water taps open until the water flowing out of the water taps
has no bubbles in it. This is the only way to ensure that the boiler is full
of water.

Set all water taps to "Cold" and leave them open. This will fill the cold
water pipes with water.

Keep the water taps open until the water flowing out of the water taps
has no bubbles in it.

Close all water taps.

Close drinking water filler neck.

Check that the cap on the water tank is not leaking.

Topping up the water

 When filling the water tank, observe the maximum permissible gross
weight of the vehicle. Luggage must be reduced accordingly when the
water tank is full.
To fill the water tank with drinking water, proceed as follows:

Open drinking water filler neck (Fig. 126).

Fill the water tank with drinking water. Use a water hose, a water canis-
ter with a funnel or similar for filling.

Close drinking water filler neck.
Sanitary fittings
Fig. 128 Safety/drainage valve closed
11
125