Charging Booster For The Living Area Battery - Capron T58 Manual

Table of Contents

Advertisement

Charging with an external
charger
9.3.5
Capron - 3141417 - 03/20 - EHG-0021-02EN
Do not connect the battery cables to the wrong poles
(red cable -> positive pole, black cable-> negative pole).
Do not actuate the ignition if the terminals of the battery are discon-
nected. Danger of short circuit!
Before disconnecting or connecting the terminals of the battery, switch
off the vehicle engine as well as the 230 V and 12 V power supplies and
all appliances. Danger of short circuit!
Before charging the battery, check whether the external charger is ap-
proved for the battery type.
Observe the instruction manuals for the base vehicle and the charger.
Irreparable damage to the battery will result if it is overcharged.
When charging the starter battery with an external charger, proceed as fol-
lows:
Turn off the vehicle engine.
Switch off all electrical appliances.
Switch off 12 V main switch on the panel. The indicator lamp will go off.
Switch off battery cut-off switch on the transformer/rectifier.
Disconnect the mains plug from the transformer/rectifier.
Switch off all gas appliances, all gas isolator taps and close the regula-
tor tap on the gas bottle.
There is a danger of short circuit when disconnecting the battery poles.
For this reason, first disconnect the negative terminal on the starter bat-
tery and then the positive.
Remove starter battery from the vehicle.
Check that the external charger is turned off.
Connect the external charger to the starter battery. Pay attention to the
polarity: First connect the positive terminal "+" to the positive pole of the
battery, then connect the negative terminal "–" to the negative pole of
the battery.
Switch on the external charger.
See the instructions for use of the connected charger for information
concerning charge period required for the battery.
See the specifications on the battery for information concerning its
strength.
Disconnect the external charger in reverse order.

Charging booster for the living area battery

 Do not carry out any maintenance or repair work on the device. There
is an electrical shock hazard and risk of fire.
 If the housing or the cables are damaged: do not put the device into
operation. Disconnect device from the power supply.
 Make sure that no liquids enter the device.
 Device components can get hot during operation. Do not touch the de-
vice. Do not store any heat sensitive objects close to the device.
Electrical system
9
91

Advertisement

Table of Contents
loading

Table of Contents