Extractor Hood (Recirculating) - Capron T58 Manual

Table of Contents

Advertisement

Switching on the grill:
Switching off:
10.3
Capron - 3141417 - 03/20 - EHG-0021-02EN
Press the control knob (Fig. 118,2 and Fig. 119,2) and turn it clockwise
(towards the grill symbol "
Press the control knob (Fig. 118,2 and Fig. 119,2) and hold it down for 5
to 10 seconds. Gas will stream into the burner.
Keep the ignition switch (Fig. 118,1 and Fig. 119,1) pressed until the
flame burns.
Once the flame is burning, the control knob must be held down for an-
other 10 to 15 seconds, until the thermocouple automatically keeps the
gas supply open.
Release the control knob and turn to the desired setting.
Turn the control knob (Fig. 118,2 and Fig. 119,2) to "". The flame
fades.
Close the gas isolator tap "Oven" and the regulator tap on the gas bot-
tle.

Extractor hood (recirculating)

 Maintain a distance of 65 cm between the extractor hood and open
flames.
 Do not flambé under the extractor hood.
The appliance is connected to the 12 V power supply.
Always switch on the extractor hood when cooking. It is advisable to
switch on the extractor hood a few minutes before you start cooking.
This causes the air to start moving and odours can be dissipated more
quickly.
After cooking, allow the air extraction to continue for a few minutes so
that any remaining odours can be neutralised.
The life of the bulbs can be extended by using the low lighting setting.
Further information can be obtained in the instruction manual for the re-
spective appliance.
Depending on the model, a recirculating extractor hood may be fitted above
the cooker. The fan draws in the cooking steam above the cooker. An acti-
vated carbon filter and a grease filter clean the air that has been drawn in
and it is then blown out again.
Appliances
") in the direction of the flame symbol.
10
117

Advertisement

Table of Contents
loading

Table of Contents