Water Tank; Drinking Water Filler Neck With Cap; Filling The Water System - Capron T58 Manual

11
Sanitary fittings
11.2
11.2.1
Opening:
Closing:
11.2.2
124

Water tank

Depending on the model, the water tank holds between 97 l and 122 l.

For driving safety and for regulatory reasons, when the vehicle is motion
the fill quantity must be reduced. If the water is drained using the safety
drainage rotary handle (see section 11.2.4), a residual quantity of ap-
proximately 20 litres will remain in the water tank.

Drinking water filler neck with cap

Fig. 126 Cap for the drinking water
filler neck
The drinking water filler neck is on the right or left side of the vehicle, de-
pending on the model.
The drinking water filler neck is indicated by the symbol "
The cap is opened and closed using the key for the external flap locks.

Insert key into locking cylinder (Fig. 126,2) and turn a quarter turn in an
anticlockwise direction.

Remove the cap.

Fill the water tank with drinking water.

Place cap on the drinking water filler neck.

Turn key one quarter turn in a clockwise direction.

Remove the key.

Check that the cap sits firmly on the drinking water filler neck.

Filling the water system

 When filling the water tank, observe the maximum permissible gross
weight of the vehicle. Luggage must be reduced accordingly when the
water tank is full.

The water pump will overheat without water and can get damaged after
one minute at the latest. Never operate water pump when the water tank
is empty.

The water quantity can be monitored on the panel while the water tank is
filled.
" (Fig. 126,1).
Capron - 3141417 - 03/20 - EHG-0021-02EN