Electrical Floor Warming Unit - Capron T58 Manual

10.2.8
Operating levels
Switching on:
Switching off:
Switching on overload
protection:
Capron - 3141417 - 03/20 - EHG-0021-02EN

Electrical floor warming unit

 On models with electrical floor warming unit, never drill holes in the
floor or screw in any screws. Careful with sharp objects. There is dan-
ger of a power cut or a short circuit due to damage to a heater wire.

Do not cover the regulator. Danger of overheating!

The electrical floor warming unit only operates if the vehicle is connected
to the 230 V power supply.

The output of the electrical floor warming unit alone is not sufficient to
heat the living area.
The regulator for the electrical floor warming unit is located in the wardrobe.
The electrical floor warming unit has four operating levels:

0 "Off"

20 V "Low heating level"

22 V "Medium heating level"

24 V "High heating level"
Fig. 114 Regulator for electrical floor
warming unit

Connect the vehicle to the 230 V power supply (see section 9.6.1).

Turn the control knob (Fig. 114,2) to the required heating level.

Turn control knob (Fig. 114,2) to "0" position.
After switching off, the floor remains warm for a while, due to residual heat.
If the regulator is overloaded, the overload protection is actuated. The pin
(Fig. 114,1) jumps out.

Press the pin (Fig. 114,1) on the overload protection when the regulator
is cooled.
10
Appliances
113