Entrance Step - Capron T58 Manual

4
Before the journey
Extending:
Retracting:
Emergency operation
26
4.4

Entrance step

 Before commencing the journey and after short interruptions of the
journey, ensure that the entrance step is completely retracted.
 Do not stand in the direct range of the entrance step while it is being
retracted or extended.
 Do not step on the entrance step until it has extended completely.
There is a risk of injury!
 Do not under any circumstances raise or lower persons or loads with
the entrance step.

Do not grease or lubricate the pivot bearing and joints of the entrance
step (see chapter 12).

The button to operate the entrance step is located on the inside of the
vehicle in the area of the conversion door.

If the entrance step has not been properly retracted and locked into
place, a warning tone is heard when the ignition is switched on.
In part, the vehicles are not equipped with an electrical entrance step but
with a low coupé entry that is comfortable to step on (model I).
Depending on the model, the vehicles have a one-or two-stage electrically
extendable entrance step.
Fig. 1 Operating switch entrance
step
Before stepping on the entrance step, fully extend it.

Press the rocker switch (Fig. 1,1) down until the entrance step has ex-
tended completely.

Press the rocker switch (Fig. 1,1) up until the entrance step has re-
tracted completely.
If the electric drive of the entrance step fails, follow the directions below to
manually retract the entrance step:

Pull out the securing splint from the connection to the engine.

Release the rectangular connection to the engine using a suitable object
(e.g. a screwdriver).
Capron - 3141417 - 03/20 - EHG-0021-02EN