Mitsubishi Electric MELSEC iQ-R Series User Manual page 152

CH1 Logging enable/disable setting
Set whether to enable or disable the logging function.
For details on the logging function, refer to the following.
Page 40 Logging Function
Setting value
0
1
Setting a value other than the above causes a logging enable/disable setting range error (error code: 1D0H).
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
CH Logging enable/disable setting
CH Logging enable/disable setting (in Q
compatible mode)
■Enabling the setting
Turn on and off 'Operating condition setting request' (Y9) to enable the setting.
■Default value
The default value is Disable (1) for all the channels.
CH1 Logging data setting
Set which data is to be collected, measured temperature value or scaling value.
For details on the logging function, refer to the following.
Page 40 Logging Function
Setting value
0
1
Setting a value other than the above causes a logging data setting range error (error code: 1D3H).
When 'CH1 Logging enable/disable setting' (Un\G535) is set to Disable (1), the setting for 'CH1 Logging data setting'
(Un\G536) is ignored.
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
CH Logging data setting
CH Logging data setting (in Q compatible
mode)
■Enabling the setting
Turn on and off 'Operating condition setting request' (Y9) to enable the setting.
■Default value
The default value is Measured temperature value (0) for all the channels.
APPX
150
Appendix 3 Buffer Memory Areas
Setting content
Enable
Disable
CH1 CH2 CH3
535 735 935
1000 1001 1002
Setting content
Measured temperature value
Scaling value
CH1 CH2 CH3
536 736 936
1024 1025 1026
CH4 CH5 CH6
1135 1335 1535
1003 1004 1005
CH4 CH5 CH6
1136 1336 1536
1027 1028 1029
CH7 CH8
1735 1935
1006 1007
CH7 CH8
1736 1936
1030 1031