Opening The Case Lid (Single-Chamber Housing); Rotation Of The Transmitter Housing - JUMO flowTRANS MAG S Series Safety Manual

3 Mounting
3.1.2

Opening the case lid (single-chamber housing)

(1) Recessed head screws
1.  Observe chapter 3.1 "Notes on opening and closing the housing", page 19!
2. Loosen the recessed head screws (1) and remove the case lid.
3. Relocate the case lid and screw down the recessed head screw (1) tightly before re-starting.
3.1.3

Rotation of the transmitter housing

(1) Transmitter housing
(2) Screw
(3) Allen screw
1.  Observe chapter 3.1 "Notes on opening and closing the housing", page 19!
2. Loosen the Allen screws (3) on the front and rear, but do not remove them completely.
3. Loosen the screws (2) and rotate the transmitter housing to the left or right by 90°.
4. Before re-starting, tighten all screws (2) and Allen screws (3) on the transmitter housing.
20
Dual-compartment housing Single-compartment housing