Atex/Iecex Zone 2 - JUMO flowTRANS MAG S Series Safety Manual

2.5.2

ATEX/IECEx Zone 2

DANGER - Risk of explosion caused by incorrect transmitter installation
The transmitters 406018/2-0 and 406019/2-0 are not Ex-approved.
The transmitters 406018/2-0 and 406019/2-0 must not be installed or operated in potentially explosive
areas.
The electrical connection between the transmitter and sensor may only be established using the signal
cable included in the scope of delivery. see chapter 2.5.3 "Signal cable length and preamplifier",
page 12.
JUMO flowTRANS MAG S01/S02
406012/2-1 (Ex-protection zone 2)
406013/2-1 (Ex-protection zone 2)
Sensor: aluminum housing
ATEX certificate:
FM15ATEX0024X:
II 3 G Ex nA IIC T6... T3 Gc
FM15ATEX0025X:
II 2 D Ex tb IIIC T85° C... T
IECEx certificate: FME 15.0006X
Ex nA IIC T6... T3 Gc
Ex tb IIIC T85° C... T
The sensors displayed above can be combined with the transmitters displayed below:
406018/2-1 (Ex-protection zone 2)
406019/2-1 (Ex-protection zone 2)
Transmitter: single-compartment housing
ATEX certificate:
FM15ATEX0024X:
II 3 G Ex nA nC IIC T4 Gc
FM15ATEX0025X:
II 2 D Ex tb IIIC T70° C Db
IECEx certificate: FME 15.0006X
Ex nA nC IIC T4 Gc
Ex tb IIIC T70° C Db
Medium
Db
Medium
JUMO flowTRANS MAG 01/02
406015/2-1 (Ex-protection zone 2)
406016/2-1 (Ex-protection zone 2)
Sensor:
ATEX certificate:
FM15ATEX0024X:
II 3 G Ex nA IIC T6... T3 Gc
FM15ATEX0025X:
Db II 2 D Ex tb IIIC T85° C... T
IECEx certificate: FME 15.0006X
Ex nA IIC T6... T3 Gc
Ex tb IIIC T85° C... T
2 Device versions
JUMO flowTRANS MAG H01/H02
Medium
Db
Medium
Db
11