Nameplate For Compact Design (Single-Compartment Housing) - JUMO flowTRANS MAG S Series Safety Manual

2.7.2

Nameplate for compact design (single-compartment housing)

A Nameplate
(1) Model number (for technical version details, see data sheet or order confirmation)
(2) Serial number for identification by the manufacturer
(3) Nominal width and nominal pressure levels
(4) T = Maximum admissible measurement medium temperature
med
T = Maximum admissible ambient temperature
amb
(5) Protection type according to DIN EN 60529
(6) Calibration value Qmax DN
(7) Transmitter communication protocol
(8) Software version
(9) CE mark
(10) Order number
(11) Customer-specific TAG number (if provided)
(12) Material: flange/lining/electrode
(13) Excitation frequency of the sensor coils
(14) Additional information: EE = Grounding electrodes, TFE = Partial filling electrode
Calibration value Ss (range)
Calibration value Sz (zero point)
(15) Accuracy with which the device was calibrated (e.g. 0.4 % of the measured value)
(16) Voltage supply
(17) Year of construction
(18) Identification marking indicating whether the pressure device falls within the scope of the Pressure Equipment
a
Directive. Specification of the fluid group taken into consideration.
Fluid group 1 = Dangerous fluids, liquid, gaseous (Pressure Equipment Directive = PED)
If the pressure device is outside the scope of the Pressure Equipment Directive
out in the SEP (Sound Engineering Practice) category according to Art. 3 Para. 3 of the PED.
If the details are completely missing, then conformity with the requirements of the Pressure Equipment Direc-
a
tive is not given. The exception for water networks and connection equipment parts according to guideline 1/
16 to art. 1. para. 3.2 of the Pressure Equipment Directive applies.
W Ex identification marking according to ATEX and IECEx (example)
C Safety plate
a
Pressure Equipment Directive (PED) 2014/68/EU (Mod. B+D).
2 Device versions
a
, the classification is carried
15