Directives; Emc-Compliant Design And Control Cabinet Configuration; Cabinet Air Conditioning; General - Siemens SINAMICS S120 Manual

Cabinet design and EMC

9.2 EMC-compliant design and control cabinet configuration

9.1.3

Directives

The control cabinet must satisfy the following EC Directives in the European Economic Area
(EEA):
Table 9- 3 Directives
Directive
2014/35/EU
2014/30/EU
2006/42/EC
9.2 EMC-compliant design and control cabinet configuration
Detailed configuration instructions regarding the EMC-compliant design of drives and control
cabinet configuration can be found in the "SINAMICS Low Voltage Configuration Manual", see
Configuration Manual for SINAMICS G130, G150, S120 Built-in Units, S120 Cabinet Modules,
S150 (https://support.industry.siemens.com/cs/ww/de/view/83180185).
9.3

Cabinet air conditioning

9.3.1

General

The minimum dimensions listed below for ventilation clearances must be observed. No other
components or cables may be installed in or laid through these areas.
NOTICE
Device failure caused by overloading of devices and components
If the guidelines for installing SINAMICS S120 Chassis devices are not observed, this can
significantly reduce the service life of the components This can result in premature device
and component failure.
• Observe the guidelines for installing the devices and components.
420
Description
Directive of the European Parliament and Council from February 26, 2014 on the approximation
of the laws relating to the provision of electrical equipment designed for use within certain volt-
age limits (Low-Voltage Directive)
Directive of the European Parliament and Council of February 26, 2014 for the harmonization of
the laws of the member states relating to electromagnetic compatibility (EMC directive)
Directive of the European Parliament and Council of May 17, 2006 on machinery and for chang-
ing Directive 95/16/EC (amendment) (machinery directive)
Air-cooled chassis power units
Equipment Manual, 06/2020, 6SL3097-5AE00-0BP3