Mounting dimensions in the control cabinet
Refer to the following diagrams for the mounting dimensions when installing a Motor
Module Chassis-2 in a control cabinet.
Front view of the control cabinet
① Side panel of the control cabinet
② Mounting surface for the Motor Module
Note
Tolerances for holes tapped in the rear mounting panel
If the specified tolerances for the threaded holes of the rear mounting panel of the control
cabinet cannot be adhered to, then compensating fastening elements should be used to
facilitate screwing in the Motor Module.
Air-cooled chassis power units
Equipment Manual, 06/2020, 6SL3097-5AE00-0BP3
Frame size FS2, FS2+
Motor Modules
6.2 Motor Modules Chassis-2
Frame size FS4, FS4+
311