Siemens SINAMICS S120 Manual page 117

• Only roll the device horizontally into the control cabinet.
Never roll the device up or down an inclined ramp, as the high weight and center of
gravity of the device pose a serious risk of injury.
• You must remove the fan unit to screw the device to the rear mounting panel.
Attaching the mounting bracket
Secure the mounting bracket of the Active Interface Module Chassis-2 on the mounting
surface of the control cabinet.
When positioning the long holes (12 mm x 17 mm), ensure that no additional pressure is
applied to the rollers of the Active Interface Modules Chassis-2 during installation.
Tighten the M10 screws to a torque of 50 Nm.
Figure 4-33
Air-cooled chassis power units
Equipment Manual, 06/2020, 6SL3097-5AE00-0BP3
WARNING
Risk of injury when rolling along an inclined ramp
Serious injury can occur when rolling along an inclined ramp as a result of the high
weight and the center of gravity.
• Only roll the device horizontally.
Attaching the mounting bracket (diagram showing an example)
Line-side power components
4.7 Active Interface Modules Chassis-2
115