Setting Up The Analyzer - Fluke OptiView T1/E1 Getting Started Manual

Setting Up the Analyzer

The analyzer's
DHCP-enabled. We suggest that you statically assign the IP
address instead of using the default DHCP setting. If you
choose to use DHCP, start at Step 2 in the following
procedure.
The overall process for setting up the analyzer is outlined below.
Follow the steps in the order given. If you need detailed instructions
for a particular step, go to the referenced section. Then, return to
complete this procedure.
1. Statically assign the IP address of the analyzer's
(see "Statically Assigning the
2. Deploy the analyzer to the location where the WAN link is to be
monitored.
3. Install a Tap on the WAN link and connect the analyzer to the Tap
(see "Installing a Tap on the WAN Link").
4. Connect the analyzer to the LAN (see "Connecting the Analyzer's
Ethernet
5. Turn on the analyzer (see "Turning on the Analyzer").
6. Connect the PC that will remotely control the analyzer to the
network (see "Connecting the PC to the Network").
7. On the remote controlling PC, install the remote user interface
software (see "Installing the Remote User Interface").
8. Start the remote user interface software (see "Starting the Remote
User Interface").
Note
port IP address is, by default,
MANAGEMENT
Port to the LAN").
MANAGEMENT
OptiView T1/E1 and DS3/E3 WAN Analyzers
Port's IP Address")
MANAGEMENT
Setting Up the Analyzer
port
MANAGEMENT
15