Table of Contents
Advertisement
Setting Analyzer Operating Parameters
To adjust system information:
1. From the Setup screen, highlight System and press the ENTER soft key. The
System menu displays:
2. Change settings to pre-selected options or to numeric values by highlighting the
option and pressing the MODIFY soft key.
For example, if one selects Filtering, then presses MODIFY, he can scroll through
the available Filtering options. If one selects an option that requires a numeric entry,
such as Time, and presses MODIFY, the entered data is cleared, and the field can
accept numeric input from the keypad until the ENTER key is pressed.
The option displayed when exiting the settings screen is saved and used for
future measurements.
The following is a description of how to change each system setting. All of these options
are accessed from the System menu of the Setup screen.
Time
The Analyzer displays hours, minutes, and seconds on the display. However, the user can
set only hours and minutes.
To set the time:
1. Highlight Time.
2. Press the MODIFY soft key to display the value field.
3. Input the desired value from the keypad. Enter time in the HHMM format where HH
is the hours in 25-hour format (0 to 23) and MM is the minutes, a number between 0
and 59.
For hour and minute values less than 10, enter a leading zero. For
example, if the time is 9:05, enter 0905.
Setting Analyzer Operating Parameters
Note
Note
Connection and Setup
fec032.bmp
2
2-13
Advertisement
Table of Contents
