Analyzer Network Connections; Setting Up The Analyzer To Test Your Network - Fluke OptiView III Series Getting Started Manual

Analyzer Network Connections

Figure 12 shows the top view of the OptiView
VGA Out Port
Figure 12. Top View of the OptiView

Setting Up the Analyzer to Test Your Network

Simply turn on the analyzer and connect a cable from the 10/100/1000 BASE-T
connector (or fiber cable) to the network. The analyzer will check the cable, find
the active network interface, and obtain a non-duplicate IP address. It will then
start discovering the network. Its advanced auto-discovery process does the rest!
You can always manually assign an IP address in the Setup | TCP/ IP screen. You
can also manually assign an IP address for an alternate network as long as it is in
the same broadcast domain.
The Front Page screen is the first screen that appears after the analyzer power-up
sequence is complete (connected to an active network), as shown in Figure 2.
15V
TM
Series III Integrated Network Analyzer
Integrated Network Analyzer
Series III Analyzer.
TM
Using the Analyzer
aww10f.eps
21