Service And Adjustment - Fluke OptiView T1/E1 Getting Started Manual

OptiView
Getting Started Guide
Table 1 describes the international electrical symbols used on the
analyzer or in the accompanying documentation.
Symbol
W
j
CAT II

Service and Adjustment

Service and adjustment of the analyzer should be performed by
trained Fluke Networks service personnel only. If you experience a
problem with the analyzer, visit the Fluke Networks website at
http:/www.flukenetworks.com, send email to
support@flukenetworks.com, or contact your nearest Fluke Networks
Service Center to report the problem (see "Contacting Fluke Networks"
for a list of telephone numbers).
If the analyzer requires repair, service center personnel will provide
you with shipping information and repair prices. If the analyzer is
covered under warranty, it will be promptly repaired or replaced (at
Fluke Networks' option) and returned to you, postage paid, at no
charge. See the registration card for warranty terms. If the warranty
has lapsed, Fluke Networks will repair the analyzer for a fixed fee and
return it, postage paid, to you.
6
Table 1. International Electrical Symbols
Warning or Caution: Risk of damage or destruction to equipment or software.
Do not connect the analyzer's network interfaces to public telephone systems.
OVERVOLTAGE (Installation) CATEGORY II, Pollution Degree 2 per IEC1010-1
refers to the level of Impulse Withstand Voltage protection provided.
Equipment of OVERVOLTAGE CATEGORY II is energy-consuming equipment to
be supplied from the fixed installation. Examples include household, office,
and laboratory appliances.
Meaning