Drilling Pattern And Installation Example - Beckhoff AX8000 Series Manual

Mechanical Installation
6.2

Drilling pattern and installation example

Before you start with the installation, make the threaded holes in the mounting plate according to the
universal drilling pattern for screwing on the AX8000 multi-axis servo system.
Universal drilling pattern
30 30 30 30
M5 M5 M5 M5
M5 M5 M5
15 30 30 30
If you equip the mounting plate with the universal
drilling pattern, you can change the configuration of
the multi-axis system at any time without having to
redrill all of the holes.
Procedure:
• Loosely screw in the three flat-head screws (M5 x 5) (1 and 2).
• Hang the AX8620 power supply module on the flat-head screw (2) and gently push it against the
mounting plate. The upper screw heads should slip through the rectangular openings into the mounting
holes.
• Tighten the three flat-head screws (1 and 2) with a torque of 3 Nm.
Mounting further modules:
• For all relevant modules, push the AX-Bridge (3) into the right end position.
• Loosely screw in the three flat-head screws (M5x5) (4 and 5).
• Hang the AX8206 axis module on the flat-head screw (5) and gently push it against the mounting plate.
The upper screw heads should slide through the mounting holes.
• The detail (6) shows the integrated mounting aid. Ensure that the bar is flush with the cutout and the
rear panels do not overlap.
• Tighten the three flat-head screws (4 and 5) with a torque of 3 Nm.
• Now open the quick couplings (7) and push the AX-Bridge (3) to the left end position for all relevant
modules. Close the quick couplings (7) again.
34
30 30 30 30 30
M5 M5 M5 M5 M5
M5 M5 M5 M5 M5
30 30 30 30 30 15
Version: 1.6 Multi axis servo system AX8000