Operation; Environmental Conditions; Installation; Safety Instructions - Beckhoff AX8-1 Series Documentation

5

Operation

5.1

Environmental conditions

Please ensure that the TwinSAFE components are only transported, stored and operated under the specified
conditions (see technical data)!
Risk of injury!
The TwinSAFE components must not be used under the following operating conditions.
• under the influence of ionizing radiation (that exceeds the level of the natural environ-
WARNING
mental radiation)
• in corrosive environments
• in an environment that leads to unacceptable soiling of the TwinSAFE component
Electromagnetic compatibility
The TwinSAFE components comply with the current standards on electromagnetic compat-
ibility with regard to spurious radiation and immunity to interference in particular.
Attention
However, in cases where devices such as mobile phones, radio equipment, transmitters or
high-frequency systems that exceed the interference emissions limits specified in the stan-
dards are operated near TwinSAFE components, the function of the TwinSAFE compo-
nents may be impaired.
5.2

Installation

Installation note
Please also refer to the installation notes on the mechanical and electrical installation of the
AX8000 in the AX8000 StartUp manual.
Note
5.2.1

Safety instructions

Before installing and commissioning the TwinSAFE components please read the safety instructions in the
foreword of this documentation.
5.2.2

Transport / storage

For transport and storage of the AX8xxx with the AX8911 TwinSAFE drive option card, use the original
packaging in which the components were delivered.
Observe the specified environmental conditions
Please ensure that the digital TwinSAFE components or the AX8000 with AX8911 Twin-
SAFE drive option card are only transported and stored under the specified environmental
CAUTION
conditions (see technical data).
5.2.3

Mechanical installation

The AX8911 TwinSAFE drive option is permanently installed in the AX8000 servo drive. Subsequent
installation or exchange of the option by the user is not possible.
AX8911 - TwinSAFE Drive Option Version: 1.0.0
Operation
17