Gendex ORTHORALIX 9200 Service Manual page 108

F.5.5 Replacing the drive belts
The belts for all the movements (X, Y, R and Cassette) are the same,
only the length is different; as spare part, a belt 1 meter long is
supplied: it is a task of the service engineer to cut the belt at the
right length, comparing the new one with the old one.
For the replacement of the X drive belt proceed as follows:
1.
Loosen the belt stretcher by unscrewing the nut (a) and then
screw (b).
2.
Remove the screws (c) with plates and replace the belt (d).
3.
Ensure that the plates are properly accommodated on the
teeth of the new belt, then fix them with securing screws
(c).
4.
For the adjustment of the belt tension refer to paragraph
Tension adjustment of the drive belts of this Section F.
Gendex Dental Systems 4519-190-71193-7
F-39
Printed on: 20 Apr 2012, 04:59:40 pm; Printed by: UWE.ZELLER
ORTHORALIX 9200 Service Manual
(03.0)E