Password Entry; Password Change - AUMA SAEx Series Operation Instructions Manual

Operation
6.4.1.

Password entry

6.4.2.

Password change

Select main menu
44
SAEx 07.2 SAEx 16.2 / SAREx 07.2
Table 24:
User levels and authorisations
Designation (user level)
Observer (1)
Operator (2)
Maintenance (3)
Specialist (4)
Service (5)
AUMA (6)
Unauthorised access due to insecure password!
We recommend changing the password during initial commissioning.
1. Select desired menu and hold down push button
Display indicates the set user level, e.g Observer (1)
2. Select higher user level via
Display indicates: Password 0***
3. Use push buttons
4. Confirm first digit of password via push button
5. Repeat steps 1 and 2 for all further digits.
Having confirmed the last digit with
user level is possible if the password entry is correct.
Only the passwords of same or lower access level may be changed.
Example: If the user is signed in as Specialist (4), he/she can change passwords as
for password levels (1) through (4).
Device configuration M0053
Service functions M0222
Change passwords M0229
Menu item Service functions M0222 is only visible, if user level Specialist (4) or higher
is selected.
1. Set selector switch to position 0 (OFF).
2. Press push button C Setup and hold it down for approx. 3 seconds.
Display goes to main menu and indicates: ▶ Display
SAREx 16.2 Control unit: electronic (MWG)
ACExC 01.2 Non-Intrusive Profinet
Authorisation/password
Verify settings
No password required
Change settings
Default factory password: 0000
Reserved for future extensions
Change device configuration
e.g. type of seating, assignment of output contacts
Default factory password: 0000
Service staff
Change configuration settings
AUMA administrator
Up ▲ and confirm with
Up ▲ Down ▼ to select figures 0 to 9.
Ok, access to all parameters within one
for approx. 3 seconds.
Ok.
Ok.