Multi-Turn Actuator With Output Drive Type B: Mount - AUMA SAEx Series Operation Instructions Manual

SAEx 07.2 SAEx 16.2 / SAREx 07.2
ACExC 01.2 Non-Intrusive Profinet
4.4.3.

Multi-turn actuator with output drive type B: mount

Procedure
SAREx 16.2 Control unit: electronic (MWG)
9. Fasten screws [3] crosswise with a torque according to table.
Table 10:
Tightening torques for screws
Threads
M6
M8
M10
M12
M16
M20
10. Turn multi-turn actuator with handwheel in direction OPEN until valve flange
and output drive type A are firmly placed together.
11. Tighten screws [5] between valve and output drive type A crosswise applying
a torque according to table.
Figure 14: Mounting output drive types B
[1] Multi-turn actuator
[2] Valve/gearbox
[3] Valve/gearbox shaft
1. Check if mounting flanges fit together.
2. Check if output drive of multi-turn actuator [1] matches the output drive of
valve/gearbox or valve/gearbox valve shaft [2/3].
3. Apply a small quantity of grease to the valve or gearbox shaft [3].
4. Place multi-turn actuator [1] and ensure that the spigot fits uniformly in the recess
and that the mounting faces are in complete contact.
5. Fasten multi-turn actuator with screws according to table.
Information: We recommend applying liquid thread sealing material to the
screws to avoid contact corrosion.
Tightening torque [Nm]
Strength class A2-80/A4 80
10
24
48
82
200
392
Assembly
21