Design Of Output Drive Types B And E; Handwheel Fitting - AUMA SAEx Series Operation Instructions Manual

SAEx 07.2 SAEx 16.2 / SAREx 07.2
ACExC 01.2 Non-Intrusive Profinet
4.2.2.

Design of output drive types B and E

Information
4.3.

Handwheel fitting

SAREx 16.2 Control unit: electronic (MWG)
Figure 9: Output drive type B
[1] Flange multi-turn actuator (e.g. F07)
[2] Hollow shaft
[3] Output drive sleeve (illustration examples)
[3] B/B1/B2 and [3]* B3/B4/E, respectively with bore and keyway
[4] Gearbox/valve shaft with parallel key
Spigot at valve flanges should be loose fit.
Connection between hollow shaft and valve or gearbox via output drive sleeve fixed
to the hollow shaft of the multi-turn actuator via retaining ring.
When exchanging the output drive sleeve, later retrofitting to a different output drive
type is possible
Output drive types B and E: Output drive sleeve with bore according to DIN
3210
Output drive types B1
5210
For transport reasons, handwheels with a diameter of 400 mm and larger are supplied
separately within the scope of delivery.
B4: Output drive sleeve with bore according to EN ISO
Assembly
17