Actuator: Mount To Valve; Stem Nut For Output Drive Type A: Finish Machining - AUMA SAEx Series Operation Instructions Manual

Assembly
4.4.

Actuator: mount to valve

4.4.1.

Stem nut for output drive type A: finish machining

Information
18
SAEx 07.2 SAEx 16.2 / SAREx 07.2
Figure 10: Handwheel
[1] Spacer
[2] Input shaft
[3] Handwheel
[4] Retaining ring
1. If required, fit spacer [1] on input shaft [2].
2. Slip handwheel [3] onto input shaft.
3. Secure handwheel [3] with retaining ring [4].
Information: The retaining ring [4] (together with these operation instructions)
is stored in a weatherproof bag, which is attached to the device prior to delivery.
Corrosion due to damage to paint finish and condensation!
Touch up damage to paint finish after work on the device.
After mounting, connect the device immediately to electrical mains to ensure
that heater minimises condensation.
This working step is only required if stem nut is supplied unbored or with pilot bore.
For exact product version, please refer to the order-related technical data sheet or
the AUMA Assistant App.
SAREx 16.2 Control unit: electronic (MWG)
ACExC 01.2 Non-Intrusive Profinet