User Level, Password - AUMA SAEx Series Operation Instructions Manual

SAEx 07.2 SAEx 16.2 / SAREx 07.2
ACExC 01.2 Non-Intrusive Profinet
Group selection
Direct display via ID
6.4.

User level, password

User level
Password
SAREx 16.2 Control unit: electronic (MWG)
Figure 36: Marking with ID
S ID starts with = status menu
S
M ID starts with = main menu
M
It is possible to select between status menu S and main menu M:
For this, set selector switch to 0 (OFF), hold down push button C for approx. 2
seconds until a screen containing the ID M... appears.
Figure 37: Select menu groups
You return to the status menu if:
the push buttons on the local controls have not been operated within 10 minutes
or by briefly pressing C
When entering the ID within the main menu, screens can be displayed directly (without
clicking through).
Figure 38: Direct display (example)
Display indicates in the bottom row: Go to
1. Press push button
Display indicates: Go to menu M0000
2. Use push buttons
3. Press push button
4. Repeat steps 2 and 3 for all further digits.
5. To cancel the process: Press C Esc.
The user level defines which menu items or parameters can be displayed or modified
by the active user.
There are 6 different user levels. The user level is indicated in the top row:
Figure 39: User level display (example)
A password must be entered to allow parameter modification. The display indicates:
Password 0***
A specific password is assigned to each user level and permits different actions.
Go to.
Up ▲ Down ▼ to select figures 0 to 9.
Ok to confirm first digit.
Operation
43