Mode 1B - Eject Drv - ADIC FastStor FastStor Mass Storage Device Installation And Operating Manual

Use the NEXT or PREVIOUS button to scroll through the slot choices. Press SELECT when the slot you wish to load is
displayed.
Your FastStor will load the desired tape into the drive. After completing the task, the FastStor will return to LdR REAdY, and the
slot number of the tape in the drive will be displayed in the center of the LCD.
EJECT DRV
Mode 1B –
Mode 1B causes the FastStor to eject the tape from the drive and place it into the storage slot that it was loaded from.
If the drive is empty, Mode 1B is not selectable on the LCD.
To access Mode 1B, press the MODE button until the LCD appears as shown:
Press the SELECT button to select Mode 1B. The LCD will appear as shown while the drive ejects the tape:
L r rea y
2 3 4 5 6
Note
eject rv
2 3 4 5 6
ejecting
2 3 4 5 6
7
7
7
Operation and Maintenance 23