Mode 1A - Load Drv - ADIC FastStor FastStor Mass Storage Device Installation And Operating Manual

To access any of the Modes, press the MODE button repeatedly until the LCD displays the desired mode on line 1.
To exit any of the Modes and return to LdR REAdY, press the MODE button.
LOAD DRV
Mode 1A –
Mode 1A causes your FastStor to load a tape into the drive.
If a tape is already loaded in the drive, Mode 1A is not selectable on the LCD, however, Mode 1B is selectable.
To access Mode 1A, press the MODE button until the LCD appears as shown:
Press the SELECT button to choose this mode. The LCD appears as shown:
If the source slot is empty, a blinking RESELECT will appear on the LCD. The blinking RESELECT indicates that you attempted to
select an invalid source slot.
22 Operation and Maintenance
It is only possible to scroll forward through the Mode choices. If you pass the mode you desire, continue to press the
MODE button until the mode you desire is again displayed on the LCD.
While accessing Modes 1-6, the FastStor is not available to your software application.
Loa
1 2 3
SRC slot
1 2 3
Notes
Note
rv
4 5 6 7
4 5 6 7
Note