Power Up Checks; Setting The Scsi Ids - ADIC FastStor FastStor Mass Storage Device Installation And Operating Manual

While the FastStor initializes, the LCD will appear as shown below. The Activity LED will blink slowly, and the Activity Bars will
appear on the LCD.
At the completion of FastStor initialization, the drive will initialize and the LCD will appear as shown below. The Activity LED
will blink fast, and the Activity Bars will appear on the LCD.
At the conclusion of drive initialization, the LCD will appear as shown below:

Power Up Checks

When you apply power to your FastStor it will perform the following actions:
Verify drive configuration and status.
Build a valid cartridge inventory log.
Calibrate the Media Picker.
When the FastStor has completed the Power Up Checks, the LCD will display LdR REAdY.

Setting the SCSI IDs

L r init
rv init
L r rea y
The default settings for the SCSI IDs are: LdR Id 1, and dRV Id 3.
SCSI ID changes are not effective until power has been cycled on the FastStor.
Notes
Operation and Maintenance 17