ADIC FastStor FastStor Mass Storage Device Installation And Operating Manual page 45

Press SELECT to choose the FastStor robotics. The LCD will appear as shown (X is the current ID of the robotics.):
Press NEXT or PREVIOUS button to scroll through the ID choices. Press SELECT when the desired ID is displayed. The
LCD will appear as shown:
Press SELECT to choose the drive. The LCD will appear as shown (X is the current SCSI ID of the drive.):
Press the NEXT or PREVIOUS button to scroll through the ID choices. Press SELECT when the desired ID is displayed.
The LCD will appear as shown below. The CYCLE PWR message will blink for approximately 10 seconds and then the
FastStor will return to LdR REAdY.
Press and hold the POWER button for approximately 2 seconds to power down the FastStor, then wait two or three seconds
and press the POWER button again. The new SCSI ID will now be in effect.
L r I x
2 3 4 5 6
rv scsi
2 3 4 5 6
rv I x
2 3 4 5 6
Cycle pwr
2 3 4 5 6
7
7
7
7
Operation and Maintenance 29