Dlt Media - ADIC FastStor FastStor Mass Storage Device Installation And Operating Manual

DLT Media

The data cartridges used in the DLT drive are housed in 4-inch plastic cases and employ ½-inch metal particle tape.
The write-protect switch is used to prevent recording over existing data. To prevent recording or deleting, place the write-protect
switch to the open position. The drive senses the position of the switch and will not allow writing in this position. When installing
cartridges in the FastStor, place the switch in the closed position (unless you do not wish to record on a specific cartridge).
If the switch is moved all the way to the left, the cartridge is write-protected and the drive cannot write to, or erase data from, the
cartridge. The small orange rectangle will be visible whenever the cartridge is write-protected. Additionally, an arrow (beneath the
orange rectangle and above the two lines on the switch) lets you know that data cannot be written to the cartridge. If the switch is
moved all the way to the right, the cartridge is write-enabled and the drive can write data to, or erase data from, the cartridge. The
orange rectangle will not be visible whenever the cartridge is write-enabled. On the right side of the write-protect switch an arrow
over one line indicates that if you slide the switch to the right, data can be written to the cartridge.
BAR CODE LABEL
WRITE-PROTECTED
DLT Data Cartridge
Store data cartridges in a dry, cool environment.
Never reset or power down your computer or FastStor while a function is in process or a tape is moving.
ORANGE
INDICATOR
WRITE-PROTECT
SWITCH
WRITE-ENABLED
Notes
Introduction 9